The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - 55.2-59 Has anybody here used a Chassis Engineering bolt-in crossmember on a Task Force?

autowrench · 10-01-2023, 01:13 PM

I continue to waffle about this decision. I like the idea that the bolt-in crossmember would add strength to the repaired frame area without welding in doubler plates. Also, I realize my welding skills are less than I had imagined. Funny how that works! I also like that they come with the adjusters for ride height. I think the Fatman kit I bought from Dan would supply everything else to finish the front suspension. I asked Chassis Engineering about this and they couldn't say definitively say yes. I have seen where people have installed this crossmember on AD trucks. I tried searching , but could not find anything specific to Task Force.

10-01-2023, 01:13 PM	#1
autowrench Registered User Join Date: May 2022 Location: Trout Creek, Montana Posts: 65	Has anybody here used a Chassis Engineering bolt-in crossmember on a Task Force? I continue to waffle about this decision. I like the idea that the bolt-in crossmember would add strength to the repaired frame area without welding in doubler plates. Also, I realize my welding skills are less than I had imagined. Funny how that works! I also like that they come with the adjusters for ride height. I think the Fatman kit I bought from Dan would supply everything else to finish the front suspension. I asked Chassis Engineering about this and they couldn't say definitively say yes. I have seen where people have installed this crossmember on AD trucks. I tried searching , but could not find anything specific to Task Force.