The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - 55.2-59 Has anybody here used a Chassis Engineering bolt-in crossmember on a Task Force?

autowrench · 10-02-2023, 12:45 PM

I downloaded the 55-59 assembly manual and I will see if I can find the front axle centerline measurement to a known spot on the frame. Heidt's and TCI specify 20 7/8" from center of front spring pin hole to the center of their crossmember. I'm sure that would not be the same for Fatman or Chassis Engineering.

10-02-2023, 12:45 PM	#11
autowrench Registered User Join Date: May 2022 Location: Trout Creek, Montana Posts: 65	Re: Has anybody here used a Chassis Engineering bolt-in crossmember on a Task Force? I downloaded the 55-59 assembly manual and I will see if I can find the front axle centerline measurement to a known spot on the frame. Heidt's and TCI specify 20 7/8" from center of front spring pin hole to the center of their crossmember. I'm sure that would not be the same for Fatman or Chassis Engineering.