The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Rebuilding / Installing Hinge Pillar to Fender Seal

Rich72C10 · 11-21-2023, 03:20 PM

Passenger side is basically installed, though I have two dodgy whole that my screw slips. Hopefully my brother has a idea to fix that.

Also, the two holes on the brace (that face through the door crack / 3rd photo), I am pretty sure those aren't screws that mount to the car but to help keep on the seal? I just don't see how those two holes could ever reach any metal. Or at least in my truck.

11-21-2023, 03:20 PM	#26
Rich72C10 Mr. Cheyenne Join Date: Jun 2020 Location: Kyle, Texas Posts: 1,687	Re: Rebuilding / Installing Hinge Pillar to Fender Seal Passenger side is basically installed, though I have two dodgy whole that my screw slips. Hopefully my brother has a idea to fix that. Also, the two holes on the brace (that face through the door crack / 3rd photo), I am pretty sure those aren't screws that mount to the car but to help keep on the seal? I just don't see how those two holes could ever reach any metal. Or at least in my truck. Attached Images __________________ Richard *'72 Chevy C10 Cheyenne Super WHT/MED BRONZE/WHT SBC 350 \| TH350 \| LWB \| AC \| Buddy Seats Upgrades:** Tilt \| Front Sway Bar \| Radio \| Sliding Window \| Bed Spare w/Lock Bed Rails \| Full LEDs \| Courtesy Lights \| Tachometer \| Glovebox Lock & Light \| Head Light Relays \| *Upgraded Fully Super Trim