|
Re: Rebuilding / Installing Hinge Pillar to Fender Seal
So on the passenger side when we were putting on the fender the top two screws were hitting the inside of the fender. So we had to pull the screws and use pop-rivets.
On the driver's side I was ready for this but then I had three screws for the brace were there wasn't any bite left in the metal. So I uses pop-rivets here too.
Also the fender next to the rocker, the 9/16 screw (like the top two at the cowl cover area) doesn't have its nut anymore in the fender. So they used a screw with a nut on the outside.
So much for "easy", that's what I get for thinking that! But I am nearly ready to put the driver's fender back on and then everything else! YAY
__________________
Richard
'72 Chevy C10 Cheyenne *Super WHT/MED BRONZE/WHT
SBC 350 | TH350 | LWB | AC | Buddy Seats
Upgrades: Tilt | Front Sway Bar | Radio | Sliding Window | Bed Spare w/Lock
Bed Rails | Full LEDs | Courtesy Lights | Tachometer | Glovebox Lock & Light | Head Light Relays | *Upgraded Fully Super Trim
Last edited by Rich72C10; 11-22-2023 at 12:28 PM.
|