The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**General23cmp** · 12-10-2023, 11:58 PM

I’m restoring a 67, and am curious if your lower cab corner lip was spot welded to the inner rocker/floor in line and similar to how the outer rocker is? My factory assembly manual says three spots go there, but my truck had none. Also, when I try to pull the cab corner and inner rocker to meet there, it doesn’t appear like they would want to be joined there (the floor flange is almost too short and you’d have to pull the two very hard to meet. I know later trucks have them welded there.

12-10-2023, 11:58 PM	#399
General23cmp Senior Member Join Date: Mar 2016 Location: Athens, AL Posts: 353	Re: My 1967 Build (Finally) I’m restoring a 67, and am curious if your lower cab corner lip was spot welded to the inner rocker/floor in line and similar to how the outer rocker is? My factory assembly manual says three spots go there, but my truck had none. Also, when I try to pull the cab corner and inner rocker to meet there, it doesn’t appear like they would want to be joined there (the floor flange is almost too short and you’d have to pull the two very hard to meet. I know later trucks have them welded there.