Quote:
Originally Posted by sakustoms
That's a nice little Sonoma. I had a 2000 stepside that I was doing an LS swap on then I sold it. It's at my BIL place in pieces along with a complete s10 worth of parts.
I just texted him this weekend and said not to scrap the parts that I wanted them.
Here I go AGAIN!!!
|
I'm sure you'd like that little thing with the V8. This same friend built one, that looks just like this one, with Escalade motor & all wheel drive. Like a later LS Cyclone!. It's crazy fun! I looked but I don't have pictures...Nabbit! Other than the hood bulge and wider they look the same. I think that's a coincidence he ended up with both the same trim, black, w/silver graphic
Quote:
Originally Posted by LT7A
Good work. It's on its way.
|
Bit by bit. I can't check my prior post while I reply here, but I have calipers and pads to install, but need to get wheel bearings/seal for the r/f. I'll get hoses, too. then it's clutch release bearing/mechanism. Then it's see about that attitude change. At this time I'm thinking 2"
Quote:
Originally Posted by Palf70Step
Is the Suburban close to getting Engine back?
|
Last we talked about it, in Oct, the heads were on but still needs finished. It has a list of things it needed that I want to catch up on that I need to get up there to take care of. Some need to wait until it's running, but I have a nice steering wheel. The truck came with a bite out of high noon. GM changed the air bag mounting, so I need to take from the old and make work for the new. p/s hoses waiting for last underhood. Oh, and it wasn't making heat. I had to replace the control head (used) and I think that one's bad or something else is up. So, that's waiting till the engine can make heat