The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - GA WTB: Z-bar/clutch frame bracket V8

**LockDoc** · 01-28-2024, 08:27 PM

-
OK, here is what I have. there are two different ones in the picture. Not sure what the difference is between V8 and I6 and not sure there is. These are both the same. I will post measurements with these to make sure....

The notch is perfect in the one showing the top view, but it does have some nicks where the rivets were removed.

The notch is perfect in the one showing the side view but it does have some marks where the nut was tightened up against it.

$10 plus $10 shipping in a small flat rate box, for either one, or $7 for "Ground Advantage" shipping in a padded envelope.
.

01-28-2024, 08:27 PM	#3
LockDoc The Older Generation Join Date: Aug 2006 Location: Montezuma, Iowa Posts: 26,121	Re: WTB: Z-bar/clutch frame bracket V8 - OK, here is what I have. there are two different ones in the picture. Not sure what the difference is between V8 and I6 and not sure there is. These are both the same. I will post measurements with these to make sure.... The notch is perfect in the one showing the top view, but it does have some nicks where the rivets were removed. The notch is perfect in the one showing the side view but it does have some marks where the nut was tightened up against it. $10 plus $10 shipping in a small flat rate box, for either one, or $7 for "Ground Advantage" shipping in a padded envelope. . Attached Images __________________ Leon Locksmith, Specializing In Antique Trucks, Automobiles, & Motorcycles (My Dually Pickup Project Thread) http://67-72chevytrucks.com/vboard/s...d.php?t=829820 - Last edited by LockDoc; 01-28-2024 at 09:02 PM.