Re: Super Cheyenne aka the "Devil Cowboy"
Got the mess cleaned up this morning and went after the lower kick panel and door rubber trim rust. The kick panel template and the piece that is cut out and ready to go is about a half inch up higher into good metal, so that should last a minute. The lower door trim area had some waves in it and looked to be about three small holes to cut out and patch.
Well after working the waves out I found that almost the whole piece would need to be fabricated and metal worked. Busted out the metal brake and some tools and whipped one out.
Everything is ready to go so hopefully later today I can get to cutting, welding, and grinding again.
|