The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

RustyPile · 09-01-2024, 04:43 PM

GM uses a unique "uniset", the points and condenser are connected together as a unit.. The proper method is to use a dwell meter to set the points with the engine running.. A dwell meter is almost impossible to find today, but it's possible to use a feeler gauge.. Before you install the distributor, rotate the shaft to set points rubbing block on one of the peaks of the shaft.. Use an allen wrench and feeler gauge, set the points gap to .018"..

If you are able to locate a dwell meter, set the points to 32 degrees.

09-01-2024, 04:43 PM	#13
RustyPile Registered User Join Date: Dec 2017 Location: Elkhart, Texas Posts: 1,888	Re: What is this distributor? GM uses a unique "uniset", the points and condenser are connected together as a unit.. The proper method is to use a dwell meter to set the points with the engine running.. A dwell meter is almost impossible to find today, but it's possible to use a feeler gauge.. Before you install the distributor, rotate the shaft to set points rubbing block on one of the peaks of the shaft.. Use an allen wrench and feeler gauge, set the points gap to .018".. If you are able to locate a dwell meter, set the points to 32 degrees.