The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Toro · 12-31-2024, 06:42 PM

After some interior work, I drove around the neighborhood today without the transmission hump installed and noticed the front driveshaft was spinning. It was in 2wd, hubs "unlocked". Factory setup 350/TH350/NP205/Dana 44. I'm guessing there shouldn't be power from transfer case in 2wd on front shaft, and maybe it just spins from going down the road?? Either way, I just noticed and wanted to be sure. Thanks.

12-31-2024, 06:42 PM	#1
Toro Registered User Join Date: Nov 2018 Location: Huntsville, AL Posts: 341	Should front driveshaft spin in 2wd? After some interior work, I drove around the neighborhood today without the transmission hump installed and noticed the front driveshaft was spinning. It was in 2wd, hubs "unlocked". Factory setup 350/TH350/NP205/Dana 44. I'm guessing there shouldn't be power from transfer case in 2wd on front shaft, and maybe it just spins from going down the road?? Either way, I just noticed and wanted to be sure. Thanks.