|
Re: Can I get some EXPLICIT steps on doing an AC delete?
If you're going to run a heater core the lines(tubs) are in a different place then the A/c lines. Weld in the big hole move the tube closer to the big hole.
Go wrecker 77-80 remove the non-A/c heater housing under dash and engine bay and heater core fire wall wiring resister and the heater temp switch and the wire rods for the flapper doors.
__________________
 1977 REG cab Long Bed with a 1984 Front Clip, 82 305 .60 over 9.0.1 flat top pistons, 4bbl, TH350, w/84 SS-intake & cam , w/ 1977 big block rad, 1975 gear box, 1984 master w/ metric fittings top & SAE fitting @ portion block, 1975 3.42 gear open diff. Duel 77-87 Factory air cleaner, duel inlet from rad support . Down sized 9' to new 8' Steel flat bed
Was a 77 454 w/308 gear. Taken out 550 lbs. up front with motor clip change.
|