Quote:
|
Originally Posted by bisquik65
I have one here on my computer desk i use for a paper weight. It is a good one and a spare one for my 69 K/20 with granny 4spd with a rockwell case. I will check for another for you. I am trying to get someone to make new ones of these. They are too hard to find. And mine was wore that bad that one hard pop of the clutch would have finished the splines off. Had to change the tranny cause the output shaft was razor sharp.
|
The Rockwell and NP205 sleeves are different. I am not sure if they will interchange.
But I have heard of the problem before. My trans output is toast, and the sleeve is toast on the transmission side. The Rockwell's input shaft is in perfect shape, tho
I got a complete trans, adapter, sleeve, and transfer case for free from a low-mile '80 K/20. The only downside is the 205 has the aluminum slip yoke tailcone. I would check ebay, as they pop up from time to time, but they won't go cheap.
I am looking to convert my truck to 32 spline. The Sm465 used with the NP208 transfer case in the 80's and the Np205 from 85-91 had a long 32 spline output, and the 205 and 208 both had female 32 spline input gears. this setup does not have an adapter sleeve and is stronger and does not wear, but it is extremely hard to find.
good luck