The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**Yukon Jack** · 09-19-2004, 11:17 AM

I just swapped in an NP205 into my 70 K5 - the prior owner said it had a Dana 20. I have all new rubber body mounts and I am using polyurethane transfer case mounts, the ones that are used to attach the adapter to the crossmember.

The NP205 is just barely touching the bottom of the K5's floor. I have not been able to torque down the bolts going through the crossmember to the adapter but I doubt that will pull the NP205 down much. I need to move the crossmember back approximately 3/8" to make it so I can bolt the adapter to the crossmember.

What kind of clearance do you all have between your floor and your transfer case?

09-19-2004, 11:17 AM	#1
Yukon Jack Post Whore Join Date: Feb 2000 Location: Rose Hill, KS, USA Posts: 12,689	NP205 floor clearance I just swapped in an NP205 into my 70 K5 - the prior owner said it had a Dana 20. I have all new rubber body mounts and I am using polyurethane transfer case mounts, the ones that are used to attach the adapter to the crossmember. The NP205 is just barely touching the bottom of the K5's floor. I have not been able to torque down the bolts going through the crossmember to the adapter but I doubt that will pull the NP205 down much. I need to move the crossmember back approximately 3/8" to make it so I can bolt the adapter to the crossmember. What kind of clearance do you all have between your floor and your transfer case? __________________ 1970 Blazer with a 400 sbc and 4" lift 1980 Pontiac Trans Am, 455 Oldsmobile 2012 Kawasaki Concours 14