The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - How do I put a pontiac BB into a 63 chevy c10

raphyel · 10-04-2004, 09:35 AM

Someone had told me to try thr 67 - 72 big block chevy brackets to make the pontiac big block fit. I went through two sets of mounts before I got it to fit, But the flat brackets when coupled with a 1970s trans am motor mounts was a perfect fit. I tested the angle of the drive shaft going into the rear end and it could not have been a straighter line. I appreciate all of the help you guys have given me. Maybe I will have it done by this time next year. I am doing a full ground up restoration. Well anyways Thanks so much.

10-04-2004, 09:35 AM	#4
raphyel Registered User Join Date: Aug 2004 Location: Cranston, RI Posts: 162	I Did It Someone had told me to try thr 67 - 72 big block chevy brackets to make the pontiac big block fit. I went through two sets of mounts before I got it to fit, But the flat brackets when coupled with a 1970s trans am motor mounts was a perfect fit. I tested the angle of the drive shaft going into the rear end and it could not have been a straighter line. I appreciate all of the help you guys have given me. Maybe I will have it done by this time next year. I am doing a full ground up restoration. Well anyways Thanks so much. Last edited by raphyel; 10-04-2004 at 09:39 AM.