[Spf79]

My pulley and bracket set up arrived today.
Install actually went smooth.

I should see my drivelines next week.
The front driveline will not have a CV, looks like I will run a 2" shaft. That should leave me plenty of room between the driveline and tranny pan.

Sadly the driver side header will not fit. I have to notch the frame a bit, but even with that - the collector points into the spring shackle making that a real tight fit. Not sure what my next move is... I don't want to cut into the frame just to see what I thought was a tight fit become a not fitting situation.

With that said, has anyone used or looked at Sanderson exhaust manifolds before?
I may go this route and use these headers in another project down the road. See the picture I pulled from another site... Thoughts?

I will post some picks of the drivelines once I pick them up and get them installed.