[landarts]

Took two days of rest and am now back at it. Decided to attack the last of the rust repair and metal work hopefully on the cab. I have one small spot on the door trim lip to address and a small area of the Captain's side kicker panel at the bottom.

Had a few challenges with the odd shapes and angles on this one. Then I had my welding wire issues on my new machine jamming up where it feeds to the gun on the inside. So what should have been an hour's worth of work to tackle these few turned into three to four hours. I guess it is part of the kicking and screaming these old trucks do when you are trying to bring them around.

Hopefully, after a few adjustments, I can get through the last of the metal work on the cab and finish up the last round of sanding filler on the back and corners of the cab. If it fights back today I have a new welding hose inner sleeve made for the .023 wire I am using. The new machine inner sleeve was for .030 and .035 wire.

Pic 1 -Hole in the cab to be repaired
Pic 2 -Repaired and ground down
Pic 3 -Holding the cut piece with tape, it would not set right with the magnet
Pic 4 -Repaired and ground down
Pic 5 -The mess after a few hours of work