View Single Post
Old 02-03-2009, 02:18 AM   #113
rfmaster
Registered User
 
rfmaster's Avatar
 
Join Date: Oct 2003
Location: OC CA
Posts: 1,374
Re: Tbi swap build thread

Quote:
Originally Posted by 408cuda View Post
Forgot to ask. I have to relocate the knock sensor for header clearance. Is the fuel pump provision acceptable even though it's not machined or open on this block? Don't see anywhere else it will fit.

Thanks!
A typical TBI system uses electrical fuel pump, which GM mounted in tank or alternatively, inline electrical fuel pump can be used instead. Typical system EFI system requires three fuel lines between tank and engine bay.
Supply line - 3/8" is used by Fuel Pump (FP) to supply fuel to TBI inlet. Please make sure that you have FP that can supply a minimum of 20 PSI. Do not go to crazy with fuel pressure as excess fuel will be bypassed and returned back to the gas tank via return line 5/16" or 3/8". Excessive fuel pump pressure tends to increase fuel temperature, which is not good - this will increase fuel vapor pressure. Third fuel line is connected to charcoal canister that connects to TBI (1/4") line.

Main DC power distribution.



//RF
__________________
"The Beast"

1975 Chevrolet C20 longbed
350/700R4! with 3inch body lift
Dual Flowmasters Super 40's!
TBI retrofit completed (2007-07-29)
New 383CID (+030) 08-304-8 9.5:1CR x36,005 (2012-12-17)

Last edited by rfmaster; 02-03-2009 at 02:51 AM.
rfmaster is offline   Reply With Quote