The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**mongocanfly** · 08-23-2016, 07:41 PM

I used -6 on all my fuel line..supply and return...how much depends on where you mount the tank and how you route the lines...I bought a 25 ft bulk roll of stainless braid and fittings from summit and made my own lengths to what I needed ..just get you some rough measurements and go from there.. it wasn't all that expensive
On your headers exhaust question I doubt your pipes will work as is..I reused my pipes from my smallblock but had to have new inlets made to connect them
Someone else may chime in but be careful about getting headers..not all will fit even though the manufacturer says they will..

08-23-2016, 07:41 PM	#2
mongocanfly Post Whore Join Date: May 2015 Location: Alabama Posts: 14,597	*Re: NOOB* about to do an LS swap** I used -6 on all my fuel line..supply and return...how much depends on where you mount the tank and how you route the lines...I bought a 25 ft bulk roll of stainless braid and fittings from summit and made my own lengths to what I needed ..just get you some rough measurements and go from there.. it wasn't all that expensive On your headers exhaust question I doubt your pipes will work as is..I reused my pipes from my smallblock but had to have new inlets made to connect them Someone else may chime in but be careful about getting headers..not all will fit even though the manufacturer says they will..