Quote:
Originally Posted by kev2809
sooo, been a little busy lately. got the carpet fully in, got the seats all bolted down (need to make one more point of mounting for those rear seats), also wired up and made my rear speaker mounts. also replaced the damaged carrier bearing for a beefy billet one.
i took a peak of where about i ride at with the ride height, and im not sure if this is how far the splines should be out on the slip shaft..any thoughts?
|
No, you should never at any time see that blue spline coating. Dana Spicer uses this coating to protect the spline from metal to metal contact and it helps extend the life of this slip joint. Also the blue coating should never be in the section of your slip yoke that has the grease zert. Right now you are way over extended on the slip.