[dsraven]

mine is long gone but I did see one on here someplace. can't remember where, its been awhile since i seen it. the fella cut the crossmember on each side, close to the frame, then welded some flat stock to the frame parts so it hung down. then he did the same on the cross member only those faced upwards and he had done the math so the frame width stayed the same. then he slid the cross member up in place and levelled it etc, marked some spots to drill holes for bolts and did it that way. exess flat bar was trimmed after. looked ok when done and did the job. it could be unbolted to acceess the trans pan or for engine removal later etc.