pdx-sanity66

[pdxhall]

Yesterday i started on getting the wiper motor removed. Of course to get it out, I had to remove the cowl. So, while I had the cowl off and removed the nut holding the linkage on the motor. I've had a seal that goes partially under the cowl. The hood on the truck has not been fitting as it should (very tight at the back) and the cowl has not fit quite right where it fits along the windshield. I decided the give the seal a try. I first loosened the cowls hold down bolts enough to slip the seal in under the cowl just far enough to raise the cowl in the front where it would fit when installed permanently. I taped it so it wouldn't fall out and carefully lowered the hood. I fits exactly how it should. So I took the cowl and put a little gasket maker on the attachment location to hold the seal in place. Next I had to put the holes in the seal. I turned the cowl over, braced it, and used one of my woodworking half-moon knives to cut the holes out. It worked out great and will be ready to reinstall when I'm done with the wipers. Today I will be taking out the wiper motor for testing and probably replacement. any way, it looks as though the cowl seal is a necessary item for fitting things up.