Brake wizards needed - I'm about to go nuts!

[mr48chev]

Originally Posted by Dashman

Sorry no wizard here, but I'm sure you'll get one.

Did you inspect the backing plate areas where the shoes make contact? ...and did you add grease? What about adding grease to the anchor pin? ...was there any wear on the anchor pin?

Did you compare both sides to each other? ...like the backing plate wear, and the axle play?

Could you feel excessive play in the axle? What about the oil level in the differential? Could that have caused your bearings to go dry? After 52 years, maybe it's time for new axles or new bearing surface welded on and machined.

Good luck!

First, I'd pull the shoes off that side and look at the pads were the shoes ride on the backing plates. Check the pads were the shoes ride for wear patterns that are in them. Take a flap wheel or grinding wheel or disk and smooth those off and put just a smear of grease on each one with your finger.

It's a pain in the tail feathers but on things like this it is better to make one change at a time rather than try doing more than one.