67 Camaro Build

[7dee2]

It's the same deal as before with the bottom, didn’t remove the cover completely. I don’t want to lose this cover's alignment that matches up so well with the bottom.

Removed and turned back the side springs then cut both sides, set it back in the car to see where to bend. A small nick with the cutoff wheel and then shaped it to clear, easy peasy! Here’s both upper and lower pieces back in the car to see what we’ve got, good to go for now.

Almost forgot to mention, yes, I did mark the area where the rollbar down bar will pass through. It looks like it will get into the upper back a little more than the bottom. Decided to collaborate with the upholstery shop on the best way to modify this area.