|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
09-22-2024, 03:11 PM
|
#1 |
|
Active Member
 
Join Date: Jun 2023
Location: Cottonwood Ca
Posts: 134
|
Hood hinges on a 69 c10
Folks, I have found a couple of sets (used) of hood hinges that are both better than mine. I have installed both sets, and it's better but I can't get the rear of the hood to sit flush with the cowling. Are the aluminum hinges the way to go? Or is there a trick with the OEM style hinges? I have tried the full range of adjustments on the rear bolts, but still haven't got them to sit low enough to be flush.
Thanks, RonWT |
|
|
|
09-23-2024, 12:01 AM
|
#2 |
|
Senior Member
Join Date: Mar 2017
Location: yucca valley
Posts: 246
|
Re: Hood hinges on a 69 c10
Following
|
|
|
|
09-24-2024, 12:03 PM
|
#3 |
|
Senior Member
Join Date: Nov 2013
Location: East Tennessee
Posts: 2,168
|
Re: Hood hinges on a 69 c10
Are you able to push it down in to place after it's closed?
Mine was the same way, I could push both sides down and it would line up. I got new hinges and that fixed it.
__________________
1967 C10 Step side 1968 C10 Step side 1970 Chevrolet K/5 Blazer 1972 Chevrolet K/5 Blazer ............. 
|
|
|
|
|
09-24-2024, 03:51 PM
|
#4 | |
|
Active Member
Join Date: Jun 2023
Location: Cottonwood Ca
Posts: 134
|
Re: Hood hinges on a 69 c10
Quote:
|
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
