![]() |
![]() |
#76 |
Senior Member
![]() Join Date: Sep 2018
Location: Belmont OH
Posts: 286
|
Re: 1950 Hudson Pacemaker
It has been quite sometime since I have posted in this thread. Today I picked up a 5.3/4L60E combo for the Hudson. Neighbor down the street is going to scrap his 2005 GMC Sierra because the frame is rotted. Traded him the Inline 6 flathead/3spd OD trans out of the Hudson. Tomorrow we are going to pick what we can from the truck before it gets hauled off. Thursdays plan is to make a trip to U-pull it and get an 8.8 rear end from a Ford Ranger to replace the Hudson rear end and that should be enough drive train pieces to keep me busy over the winter.
|
![]() |
![]() |
![]() |
#77 |
Proprietor of Dale's Corner
![]() Join Date: Nov 2012
Location: Vacaville , CA
Posts: 16,115
|
Re: 1950 Hudson Pacemaker
The plan sounds great. It's also great to see progress!!
__________________
"Some Days Chickens And Some Days Feathers" Dale XNGH ECV Sam Brannan 1004 R.I.P. 67ChevyRedneck R.I.P. Grumpy Old Man |
![]() |
![]() |
![]() |
#78 |
Senior Member
![]() Join Date: Sep 2018
Location: Belmont OH
Posts: 286
|
Re: 1950 Hudson Pacemaker
Todays harvest of the donor vehicle consisted of the tilt steering column with harness and fuse box, and the HVAC unit complete with ductwork and wiring.
|
![]() |
![]() |
![]() |
Bookmarks |
|
|