|
Today, 06:41 PM
|
#1 |
|
Registered User
Join Date: Dec 2017
Location: Wichita, KS
Posts: 61
|
HEI in 283?
I have a 67 C10 with a 283. It's not the original 283, but it looks to be mostly original configuration, except for an Edelbrock intake and 500cfm 4-brl. Is there any reason that makes it not possible to put in an HEI distributor? Good idea? Bad idea? pros? cons? Any particular brand?
Thaks for any advice |
|
|
|
Today, 06:51 PM
|
#2 |
|
Senior Member
 
Join Date: Oct 2009
Location: Godley, TX
Posts: 17,963
|
Re: HEI in 283?
You can install an HEI on your 283. Recommend browse around on here for all the installation tips folks have provided over the years - things like full 12V, etc.
HEIs are a good idea because they eliminate the points (and therefore point wear, need to change/adjust every once in a while, etc) and are reliable (although I'd avoid overseas-made new ones - the best ones are the original GM HEIs - and some very reputable, but sometimes pricey, new U.S. made HEIs). The only con is non-original appearance. If that matters to you, you may want to consider a pertronix unit that also eliminates the points but fits under your current distributor cap. |
|
|
|
Today, 07:35 PM
|
#3 |
|
Senior Member
Join Date: Feb 2002
Location: Tucson, AZ USA
Posts: 7,287
|
Re: HEI in 283?
Why not? HEI will fit any SBC V8.
__________________
Every 25 years I like to rebuild that 292, whether it needs it or not. |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
