Super Cheyenne aka the "Devil Cowboy"

[landarts]

Got the truck rolled back into the garage early this morning. Wanted to get a few areas on the cab into some surface primer. Went over the areas with wax and grease remover and found a few small areas that need a little attention. First I noticed that the rear window channel needed another once-over with a wire wheel on a battery-operated drill to clean up a few spots of whatever was stuck to the frame underneath the rubber when it was removed. I had earlier treated the frame area with Ospho for rust treatment, so after I went another round with the wire wheel I masked it off and sprayed some Rustoleum Rust Reformer for extra protection.

Moved onto the drinker side lower corner had two small areas that needed a little filler and glaze to make it right before primer. Once those areas were addressed I could wipe it down again and spray some black surface primer again. Going to let that cure up for a few hours before sanding. In the meantime, I will get the doors and fenders up on the stand and do a once-over to see if they are ready for another coat of surface primer.

Pict 1-Back of cab rear window frame masked off and sprayed with Rust Reformer
Pict 2-Back corner of cab getting a few touch-ups with filler and glaze
Pict 3-Getting outer door frame and rocker area ready for primer the
Pict 4-Door area sprayed
Pict 5-Back of cab sprayed