|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
02-01-2013, 07:30 PM
|
#1 |
|
Registered User
Join Date: Jun 2012
Location: jackson, ohio
Posts: 304
|
400 slip yoky question
When installing a 400 turbo in a lwb truck with 2pc driveshaft how far should i pull the slip yoke out to get a measurement on cutting driveshaft
Posted via Mobile Device |
|
|
|
02-01-2013, 07:49 PM
|
#2 |
|
Registered User
Join Date: Oct 2010
Location: El Mirage AZ
Posts: 169
|
Re: 400 slip yoky question
http://www.dennysdriveshaft.com
you can check this site for how to measure for one, on a one piece you need about 3/4-1 of shaft play, |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
