![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Mar 2003
Location: Cheboygan, MI
Posts: 998
|
Truck run rough? Change the u-joints!
This may seem obvious, but I just had to post how much better my truck rides with new u-joints. Wow, what a difference... I always thought it was a combination of the 33s, 205, sm465 and stiff springs that made it rough at speed. Now it's pretty nice at 65mph.
Still a truck, of course... ![]()
__________________
Tony Johnson -- '71 Blazer w/L-31 Vortec 350, SM465, NP205, performer intake, edelbrock 1406, HEI, 4" lift, Boyd EFI tank, Vintage A/C My Blazer -- Last edited by TonyJohnson; 08-09-2009 at 10:43 AM. |
![]() |
![]() |
![]() |
#2 | |
just can't cover up my redneck
Join Date: May 2004
Location: Columbus OH
Posts: 11,414
|
Re: Truck run rough? Change the u-joints!
Drive shaft? or front axle?
I am assuming that you are refering to the rear drive shaft and that you had a vibration of some kind... But be aware that if the front axle joints get stiff on you, replacing them will make a huge difference in the way it drives too. BTW, this is how it rides or drives......not how it runs.
__________________
You can review the site's rules here. Quote:
Bad planning on your part does not necessarily constitute an instant emergency on my part.... The great thing about being a pessimist is that you are either pleasantly surprised or right. ![]() |
|
![]() |
![]() |
![]() |
#3 | |
Registered User
Join Date: Mar 2003
Location: Cheboygan, MI
Posts: 998
|
Re: Truck run rough? Change the u-joints!
Quote:
Good point ont runs vs rides. I changed it in the body of the post, but can't change the title.
__________________
Tony Johnson -- '71 Blazer w/L-31 Vortec 350, SM465, NP205, performer intake, edelbrock 1406, HEI, 4" lift, Boyd EFI tank, Vintage A/C My Blazer -- |
|
![]() |
![]() |
![]() |
Bookmarks |
|
|