|
04-29-2005, 09:21 AM
|
#1 |
|
Registered User
 
Join Date: Mar 2002
Location: Dallas, TX
Posts: 555
|
Front Wheel Bearings
Are the wheel bearings for a Dana 44 front axle the same for 1/2 and 3/4 ton? This would be for a 1975 open knuckle.
Erl
__________________
1968 GMC 305 V6 3/4 4x4 Stepside 06 Corvette Daily Driver Dallas TX Last edited by Erl; 04-29-2005 at 09:22 AM. |
|
|
|
04-29-2005, 09:20 PM
|
#2 |
|
Senior Member
Join Date: Mar 2003
Location: Colfax-California
Posts: 8,717
|
The inner bearing is usually larger for the 3/4 ton. Are they 'bolt-on' locking hubs? In 77 or 78 when GM went to the 10 bolt they used the same spindle for both.At that time they aslo used the same locking hub which had the internal spline in the rotor assy. The 3/4 spindle from 73-76 took an inner bearing of 362 [i think]
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
