|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-03-2010, 08:15 AM
|
#1 |
|
Registered User
Join Date: Feb 2009
Location: minonk illinois
Posts: 224
|
Oil pressure gauge line replacement
I would like to hook up my factory oil pressure gauge using a AN type hose and fittings anyone done this do I need any special adapter to connect to factory gauge? I did a search but couldnt find it. It is a 72 K5
|
|
|
|
04-03-2010, 10:13 AM
|
#2 |
|
Senior Member
 
Join Date: Sep 2000
Location: Agency IA.
Posts: 1,889
|
Re: Oil pressure gauge line replacement
this is will work http://www.jegs.com/i/Auto-Meter/105...oductId=745223
__________________
72 Chevy short step side with 454 air and tilt. 72 nova project car 63 chevy II drag car Agency Iowa |
|
|
|
|
04-03-2010, 08:38 PM
|
#3 |
|
Registered User
Join Date: Feb 2009
Location: minonk illinois
Posts: 224
|
Re: Oil pressure gauge line replacement
thanks
|
|
|
|
|
04-03-2010, 08:56 PM
|
#4 |
|
Registered User
Join Date: May 2009
Location: Eliot, Maine
Posts: 1,314
|
Re: Oil pressure gauge line replacement
just be sure there are no leaks.....rusted pipe or loose connections can slowly bleed your engine dry over time.
i am replacing the line on my 72 burb 'cause it twisted on me today when i removed it from the engine block to make room to clean the deck surface for doing an intake carb swap. going from the stock rochester 2 barrel to an early 80's q-jet on top of an edelbrock (low rpm range) intake. |
|
|
|
|
04-03-2010, 08:58 PM
|
#5 |
|
Senior Member
Join Date: Jun 2007
Location: Pine Ridge Florida
Posts: 4,138
|
Re: Oil pressure gauge line replacement
__________________
Click on my Not really a build thread, yet NOT SO RUST FREE RUST FREE BLAZER LS ENGINE SWAP INFORMATION THREAD BOLT RESTORATIONS 4l60 to an NP205 |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
