![]() |
![]() |
#1 |
Registered User
Join Date: Jun 2001
Location: Casper,Wyo. 82604
Posts: 2
|
![]() Ok im building a 350 68-76 Engine 2 bolt main, 40 over flat top Badger pistons, Rv cam. Now im hearing about these camel humps do i use them with todays fuel Blends,Compression? or do i get a good set of heads and shave 10ths off the heads. And what will this do for me. It is a 4x4 pickup??/ Please any info would help.
__________________
Mark |
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Jun 2001
Location: KINGWOOD TEXAS
Posts: 515
|
![]()
With your average thick head gasket the auto parts are selling your talking around 9.5 to 9.7 compression depending on pistons (ie dish=less. or flat with -7--9 cc's). You can usually run today's gas with this setup, cam has a lot to do with it. Wanna buy a set I have two extra.
__________________
Member of the "Old Farts Club" |
![]() |
![]() |
![]() |
Bookmarks |
|
|