|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
08-28-2016, 06:28 PM
|
#1 |
|
Registered User
 
Join Date: Dec 2012
Location: Vancouver, Washington
Posts: 1,644
|
Fuel pump connection question
I'm attempting to adapt an Edelbrock fuel line connector that was supplied in one of their kits to my stock fuel pump. As seen in the picture, the conical reverse flare -6AN side fits the fuel line connector. The pipe thread side is a little too large to thread into the pump outlet. Can anyone help with an adaptor choice that would work? For the stock fuel pump? Thank you
Posted via Mobile Device
__________________
1968 Chevrolet C/10 LWB - 327, TH350 - 4/5 Drop |
|
|
|
08-28-2016, 06:49 PM
|
#2 |
|
Registered User
Join Date: May 2000
Location: Frankfort, Kentucky, USA
Posts: 2,163
|
Re: Fuel pump connection question
The fitting pictured is for a pipe thread. Your stock fuel pump should be set up for an inverted flare. You could buy an inverted flare to -6 AN fitting or see if the inverted flare on the stock pump is removable. If so, it's probably a pipe thread behind it. My Holley pump has 3/8 npt threads. That fitting would go directly in it.
__________________
'69 CST Short fleetside Lowered, 400 small block, 700R4, 4 wheel disc brakes, front sway bar & rear camaro sway bar (in progress) '87 V10 4x4 Short Fleetside Quad Suspension and Dual Tanks |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
