|
Lower A arm shaft (feels rough)
so in the process of putting in drop spindles I noticed that one of my lower A arm shafts feels "rough". On spins freely, but yet the other binds a bit. I tried lubing it with a grease gun, still felt stiff, even after working it back and forth for a while after lubing. Before I spend the $ to get new ball joints pressed into this arm....
is there a way to rebuild the shaft?
what is the wear item in there? a bearing? a bushing? just a metal to metal connection? is it tough to rebuild them?
Last edited by Choptop32; 05-08-2010 at 07:32 PM.
|
05-08-2010, 05:57 PM
Threaded Mode