My 1st project on my 1st truck... have questions... - The 1947 - Present Chevrolet & GMC Truck Message Board Network

amstaff · 11-16-2002, 07:38 PM

My first project is to replace coil springs... I have a 350 in the truck, If I installed 1/2 ton Big Block springs up front will that help keep the front up by an inch or so? The only reason I would do this is if I can get about an inch up front to level out the rake at least a little. Also, I was told variable rate springs have same ride as stock 1/2 ton, but when put under weight they will perform as if a 3/4 ton. Anyone have experience with this? Don't know if I should install variable in rear or 3/4 ton springs. Will I totally ruin ride quality by going w/ BB up front and 3/4 ton in rear? Any input would help me out greatly.
Greg

11-16-2002, 07:38 PM	#1
amstaff Registered User Join Date: Oct 2002 Location: State College, PA Posts: 178	My 1st project on my 1st truck... have questions... My first project is to replace coil springs... I have a 350 in the truck, If I installed 1/2 ton Big Block springs up front will that help keep the front up by an inch or so? The only reason I would do this is if I can get about an inch up front to level out the rake at least a little. Also, I was told variable rate springs have same ride as stock 1/2 ton, but when put under weight they will perform as if a 3/4 ton. Anyone have experience with this? Don't know if I should install variable in rear or 3/4 ton springs. Will I totally ruin ride quality by going w/ BB up front and 3/4 ton in rear? Any input would help me out greatly. Greg

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.