The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current Classic GM Trucks Classifieds > The 1967-1972 Chevrolet & GMC Pickups Parts Board

Web 67-72chevytrucks.com


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 12-05-2004, 07:15 PM   #1
ScottH
Senior Member
 
ScottH's Avatar
 
Join Date: Sep 2002
Location: Hampstead, NC
Posts: 8,193
FS: 1972 C10 96k clean lwb

1972 Cheyenne Super 1/2 Ton Posi Rear Pickup with 96,00 original miles, 350 C.I. V-8 engine, 3 speed on the tree. This is an unmolested truck I purchased from the original owners family, runs EXCELLENT, very little rust. Rockers and corners were replaced at some time, not professional but I've seen worse. Small dent in drivers fender and ps lower front bed panel.

Some of the items PO replaced recently include:
Master Cylinder & Fluid, Front Brake Caliper, Front brake pads, Starter, Cam Shaft (Towing), Lifters, Rockers, Push Rods, Windshield, Heater core, Thermostat, & Hoses, reupholstered Seat, Custom bent Dual Exhaust W/Turbo Flow Mufflers, Points, Plugs, Rotor, Dist. Cap, battery, rebuilt carb.

Now for the bad, the following need to be repaired/replaced:
Shifter column cone (pin worn), gas and temp guage, dash pad, arm rests.
I have a new column cone and guages which are included.

I am asking $1500 on the board before it goes to ebay. Any questions or other pics please let me know.
Attached Images
    
ScottH is offline   Reply With Quote
 

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 02:05 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright 1997-2025 67-72chevytrucks.com