|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
03-08-2012, 08:46 PM
|
#1 |
|
Registered User
Join Date: Mar 2006
Location: massachusetts
Posts: 180
|
72 steering column installation problem?
Iam restoringa 72 c-20 pickup and the steering column is got me puzzled. Every time I tighten up the three screws that hold down turn signal the turn signal support tightens up cockeyed. The cone and the signal support dont lay flat . What to do?
__________________
I know I can! I know i can! 72 K20 Restoration |
|
|
|
03-09-2012, 12:58 AM
|
#2 |
|
The Older Generation
   
Join Date: Aug 2006
Location: Montezuma, Iowa
Posts: 26,099
|
Re: 72 steering column installation problem?
-
That is a tough one without seeing it in person. Is it a tilt? How far apart did you have it? If the cast aluminum piece is all the way down and square it should all bolt together. I would say something is not seated down correctly. Check the hazard flasher part of the switch and see if it is not in place. LockDoc
__________________
Leon Locksmith, Specializing In Antique Trucks, Automobiles, & Motorcycles (My Dually Pickup Project Thread) http://67-72chevytrucks.com/vboard/s...d.php?t=829820 - |
|
|
|
|
03-09-2012, 04:46 PM
|
#3 |
|
Registered User
Join Date: Oct 2005
Location: Overland Park, Ks.
Posts: 5,229
|
Re: 72 steering column installation problem?
There are grooves in the bottom of the die cast part that must fit in the edge of the jacket. You may not have them lined up.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
