|
06-06-2004, 11:24 PM | #1 |
Registered User
Join Date: May 2000
Location: Ballston Lake, NY
Posts: 161
|
Coil Resistor Wire
My coil reads: "12V External Resistance Wire Required". My coil is feed from a yellow wire out of the harness. How do I know if this is a "Resistance" wire. I keep reading about a "white braided" wire. Thanks, Joe Bob.
|
06-06-2004, 11:43 PM | #2 |
Almost done!
Join Date: Apr 2004
Location: Woodstock GA
Posts: 193
|
Joe Bob,
The best way to be sure is to use a volt meter to measure the voltage. If you measure around 12.6 volts, your wire is not a resister wire, if it measures around 9 volts, it is the correct wire with correct voltage. If you run the full 12 volts, it will burn up the points. (real fast) If you do not have a volt meter, you can pick one up at most discount stores for less than $15.00. Good luck! Kelly
__________________
The 1970 SWB Project Removed 6cyl manual trans, manual everything V8-350 Auto/PS/PDB Blazer Fuel Tank Behind the Marker Light Fuel Fill |
06-06-2004, 11:44 PM | #3 |
Registered User
Join Date: Jun 2002
Location: Knoxville Tenn.
Posts: 3,058
|
It is--it is spliced into the resistance wire in the harness as the yellow wire also goes to the starter "R" post so that you get a full 12 volts when cranking for easier starting --when starter is released the current flows from ing. switch through the resistance wire to yellow wire to coil.
__________________
56 Chevy Bel-Air 2dr. HT (purchased new) 71 Chevy Cheyenne SWB PU (502HO) 65 GMC short bed step--work in progress and my gofer |
06-07-2004, 12:15 AM | #4 |
Registered User
Join Date: May 2000
Location: Ballston Lake, NY
Posts: 161
|
Great info! Thanks guys!
|
Bookmarks |
Thread Tools | |
Display Modes | |
|
|