![]() |
|
![]() |
#1 |
3 lefts make a right
Join Date: Jun 2004
Location: Texas Hill Country
Posts: 150
|
Dimmer Switch
I had my truck inspected today and everything was good exept for my dimmer switch. It was stuck in the high beam mode and would not switch to low. We replaced it and all is well but what has me concerned is that when we pulled the old one out it was very hot. Could this be due to it stuck in the High setting or it just shorted out?
|
![]() |
![]() |
![]() |
#2 |
You get what you pay for
![]() Join Date: Dec 1999
Location: Cherryville, NC
Posts: 4,798
|
It may have been shorted and stuck on the high side. Not to worry though. You took care of it. Check the wiring to make sure you don't have any places where it might short out.
__________________
Mike 1985 Chevy C-10 |
![]() |
![]() |
![]() |
#3 |
3 lefts make a right
Join Date: Jun 2004
Location: Texas Hill Country
Posts: 150
|
Everything looks good with the wiring. Thanks for the quick reply Mike.
|
![]() |
![]() |
![]() |
#4 |
Registered User
Join Date: Jan 2004
Location: Paso Robles, CA
Posts: 347
|
Sounds like an easy fix. Good Job
|
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|