Where to the jack accessories go?? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

norville · 12-10-2004, 08:45 AM

Hey folks,

I found out where the jack goes but where do the extension arms and lug wrench go??? Also anyone have a pic of how the spare goes??? under hte bed , I think I'm missing some parts.

thanks
norville

beaterC10 · 12-10-2004, 09:21 AM

The jack accessories are clamped to one of the inner front fenders. Most of the time they are installed on the passenger side. The later trucks may have it on driver side.

The spare tire carrier is a flat bar that has a bracket to catch the wheel. This bar is suspended diagonally behind the rear axle with a couple of threaded rods. It's terrible to use, impossible on a lowered truck, and normally removed to route duals.

badone07 · 12-10-2004, 12:36 PM

Here's a thread. Guess these were needed again after all.

http://207.44.196.117/vboard/showthr...highlight=jack

norville · 12-10-2004, 01:37 PM

thanks thats what I needed looks like All I need is the jack hold-down and wingnut

norv

12-10-2004, 08:45 AM	#1
norville Senior Member Join Date: Jun 2004 Location: Mountain Top, Pa Posts: 323	Where to the jack accessories go?? Hey folks, I found out where the jack goes but where do the extension arms and lug wrench go??? Also anyone have a pic of how the spare goes??? under hte bed , I think I'm missing some parts. thanks norville __________________ 1986 C10 Scottsdale 5.3, TH400

12-10-2004, 12:36 PM	#3
badone07 Project 2 Resume Join Date: May 2004 Location: Jim Thorpe, PA Posts: 884	Here's a thread. Guess these were needed again after all. http://207.44.196.117/vboard/showthr...highlight=jack __________________ John 1984 C30 Chevy Crew Cab Dually 1998 Jeep Cherokee 4x4 2004 Chevy Trailblazer 4x4 (wife's) 1970 Mustang FB fully tubed (getting 521 BBF & powerglide) 1978 Nova 2dr (going BBCaddy & S.P. th400) 1984 Monte SS (circle track car)

12-10-2004, 01:37 PM	#4
norville Senior Member Join Date: Jun 2004 Location: Mountain Top, Pa Posts: 323	thanks thats what I needed looks like All I need is the jack hold-down and wingnut norv __________________ 1986 C10 Scottsdale 5.3, TH400

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

12-10-2004, 09:21 AM	#2
beaterC10 Senior Member Join Date: Jul 2003 Location: Indianapolis, IN Posts: 1,277	The jack accessories are clamped to one of the inner front fenders. Most of the time they are installed on the passenger side. The later trucks may have it on driver side. The spare tire carrier is a flat bar that has a bracket to catch the wheel. This bar is suspended diagonally behind the rear axle with a couple of threaded rods. It's terrible to use, impossible on a lowered truck, and normally removed to route duals.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.