![]() |
|
![]() |
#1 |
Registered User
Join Date: Aug 2004
Location: phoenix az
Posts: 105
|
IFS for a 67 SWB
Does anyone make a IFS with rack steering for the 67 Chevy SWB. I thought I found one on google but can't remember what there site was now.
|
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 21,977
|
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. |
![]() |
![]() |
![]() |
#3 |
WTB this ad
Join Date: Sep 2004
Location: Lafayette Georgia
Posts: 5,074
|
I think Fatman Fabrications makes a bolt in crossmember for 60-87 trucks. I'm not sure what they cost but I think they advertise in Classic trucks, or you could Google them.
|
![]() |
![]() |
![]() |
#4 |
Registered User
Join Date: Dec 2002
Location: Tampa
Posts: 1,191
|
See pictures of the Fatman Stage III kit in a link in my sig. They have four or five different kits. I think Martz Chassis makes one also along with Scott's.......nevermind the last one.
__________________
'68 Short Step LS1/T56, Hydratech, Fatman Fabrications Stage III, Baer, Hot Rods to Hell, US Body, S&W, etc |
![]() |
![]() |
![]() |
#5 |
Registered User
Join Date: Aug 2004
Location: phoenix az
Posts: 105
|
Thanks I looked at your pictures. Thats a nice IFS setup. I want to do a IFS and 4 link. This is going to be a drag/show truck so I figure the full racing 4 link in the rear would be the best.
Last edited by kell490; 07-01-2005 at 07:23 PM. |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|