Reproduction Dual Exhaust Hanger Brackets - The 1947 - Present Chevrolet & GMC Truck Message Board Network

badpeanut · 09-07-2006, 07:52 PM

Per http://www.gmcpauls.com/parts_coming_soon.htm:

Quote:

1969-72 Exhaust hanger bracket. These are just like those found on the factory original dual exhaust trucks. Specify left or right in cart.

Anybody know which hanger(s) it will be (front, mid, rear, coil, leaf, left, right)? Sounds like one part number, but there are a bunch of hangers out there.

qksilver · 09-07-2006, 08:40 PM

I was lucking to get a complete set off of a frame I got from Bills Bowtie. There are , as I remember, 3 different ones, I think the difference would be 2 wheel or four wheel rather than leaf or coil. Every 2 wheel leaf frame I have tried to find to replace my swb 4x4 frame has the same bends around the axle as the coil. The 4X4 frame is straight over the axle

09-07-2006, 08:40 PM	#2
qksilver Senior Member Join Date: Dec 2004 Location: Southern Pines NC Posts: 3,853	Re: Reproduction Dual Exhaust Hanger Brackets I was lucking to get a complete set off of a frame I got from Bills Bowtie. There are , as I remember, 3 different ones, I think the difference would be 2 wheel or four wheel rather than leaf or coil. Every 2 wheel leaf frame I have tried to find to replace my swb 4x4 frame has the same bends around the axle as the coil. The 4X4 frame is straight over the axle

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.