|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
12-23-2006, 01:34 PM
|
#1 |
|
Registered User
Join Date: Oct 2006
Location: Arizona
Posts: 835
|
stepside bed mounting pads
Hey Everyone
Can someone tell me how thick the rubber bed mounting pads are? |
|
|
|
12-23-2006, 02:13 PM
|
#2 |
|
Registered User
Join Date: Nov 2003
Location: Alexandria, VA
Posts: 1,534
|
Re: stepside bed mounting pads
This may sound a bit backwoods, but just get an old inner tube and cut some squares about 3X3 inches and cut a hole in them for the bolt to pass through. Works like a charm...
__________________
'72 GMC SWB C1500 Custom, frame-off in progress. 383 SBC, 9:1CR, Comp Cams XE262H, Scat internal balanced crank, Eagle SIR 6" rods, Keith Black dish pistons, Dart Iron Eagle 72/180 heads, Weiand Stealth intake, Stewart stage I water pump, Holley 4bbl vac sec, TH350 with B&M Shift Improver Kit. 12 bolt positraction.   
|
|
|
|
|
12-23-2006, 03:18 PM
|
#3 | |
|
Registered User
Join Date: Oct 2006
Location: Arizona
Posts: 835
|
Re: stepside bed mounting pads
Quote:
|
|
|
|
|
|
12-23-2006, 08:59 PM
|
#4 |
|
Senior Member
 
Join Date: Sep 2000
Location: Agency IA.
Posts: 1,845
|
Re: stepside bed mounting pads
I used an old slick
__________________
72 Chevy short step side with 454 air and tilt. 72 nova project car 63 chevy II drag car Agency Iowa |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
