|
06-25-2007, 12:08 AM | #1 |
STOLEN
Join Date: Jun 2006
Location: Orange County
Posts: 1,022
|
Crossmember Question
I want to replace my crossmember hardware as some are missing and/or in bad shape. The existing are just hex head, no flange with one lock washer. When I replace with Grade 8, should I add flat washers?
__________________
In Search Of |
06-25-2007, 12:09 AM | #2 |
Registered User
Join Date: Mar 2006
Location: USA
Posts: 21,020
|
Re: Crossmember Question
I did on the motor and t-case crossmembers...
|
06-25-2007, 12:14 AM | #3 |
STOLEN
Join Date: Jun 2006
Location: Orange County
Posts: 1,022
|
Re: Crossmember Question
What length bolt did you replace with?
__________________
In Search Of |
06-25-2007, 12:18 AM | #4 |
Registered User
Join Date: Mar 2006
Location: USA
Posts: 21,020
|
Re: Crossmember Question
I will check tomorrow,I forget.I put them in back in February so I dont remember...... The new grade 8s I used arent much longer than the old ones though...
Last edited by 1969k10stepside; 06-25-2007 at 12:24 AM. |
06-25-2007, 12:25 AM | #5 |
STOLEN
Join Date: Jun 2006
Location: Orange County
Posts: 1,022
|
Re: Crossmember Question
Thanks Dustin, your build is looking awsome.
__________________
In Search Of |
06-26-2007, 10:49 PM | #6 |
Registered User
Join Date: Mar 2006
Location: USA
Posts: 21,020
|
Re: Crossmember Question
Thanks,the bolts are about 2 and 1/2 inches long,they are a little long but they work...I use a lock washer,and a regular flat washer on it
Last edited by 1969k10stepside; 06-26-2007 at 10:50 PM. |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|