305 sitting on the floor? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**truckdude239** · 10-11-2007, 07:18 AM

okay guys if you saw the post over in the gd section the motor for my 71 fell and crushed me roommates fingers. it been sitting in the floor for a week now (dont have anyone that can help get it back up) anyway its a 305 bored 30 out never been run its wrapped up in pallet wrap therers no oil in it or anything so will it hurt anything sitting in the floor on its side? i dont think it will just want to make sure

chris71 · 10-11-2007, 09:32 AM

I am not an engine builder but i would assume it would be ok. I would be more worried about if any damage was done to it depending on how hard it hit the floor and where it hit. I would go over the engine with a fine tooth comb looking for cracks in the block etc. It would suck to not check it over before you put it in ad then find out something wasnt right. good luck man.

**truckdude239** · 10-11-2007, 11:02 PM

it looks fine it sort of had a soft landing right on e roomates hand

10-11-2007, 07:18 AM	#1
truckdude239 Senior Member Join Date: Sep 2005 Location: Lewisville, Nc Posts: 10,237	305 sitting on the floor? okay guys if you saw the post over in the gd section the motor for my 71 fell and crushed me roommates fingers. it been sitting in the floor for a week now (dont have anyone that can help get it back up) anyway its a 305 bored 30 out never been run its wrapped up in pallet wrap therers no oil in it or anything so will it hurt anything sitting in the floor on its side? i dont think it will just want to make sure __________________ David fuller Ase Certified Mechanic Click here to help support our board!! 1971 Chevy c-10 under going a 4.8l LSx swap Build Thread http://67-72chevytrucks.com/vboard/s...d.php?t=421305 2007 Honda Accord my daily 145kmiles 2002 Honda Accord 4 door With 330k(sisters car) 2005 toyota Avalon 228k( brothers car) 2002 Sububran 5.3 245k 2000 Tahoe 5.3l 378 General manager for Marco's Carwash & lube

10-11-2007, 09:32 AM	#2
chris71 Registered User Join Date: Oct 2007 Location: Sykesville MD Posts: 357	Re: 305 sitting on the floor? I am not an engine builder but i would assume it would be ok. I would be more worried about if any damage was done to it depending on how hard it hit the floor and where it hit. I would go over the engine with a fine tooth comb looking for cracks in the block etc. It would suck to not check it over before you put it in ad then find out something wasnt right. good luck man. __________________ '55 3100 2nd series short-bed stepside '70 Corvette coupe stingray '71 Chevelle 2-dr coupe SS clone '71 C10 long-bed fleetside '83 long-haired brunette wife

10-11-2007, 11:02 PM	#3
truckdude239 Senior Member Join Date: Sep 2005 Location: Lewisville, Nc Posts: 10,237	Re: 305 sitting on the floor? it looks fine it sort of had a soft landing right on e roomates hand __________________ David fuller Ase Certified Mechanic Click here to help support our board!! 1971 Chevy c-10 under going a 4.8l LSx swap Build Thread http://67-72chevytrucks.com/vboard/s...d.php?t=421305 2007 Honda Accord my daily 145kmiles 2002 Honda Accord 4 door With 330k(sisters car) 2005 toyota Avalon 228k( brothers car) 2002 Sububran 5.3 245k 2000 Tahoe 5.3l 378 General manager for Marco's Carwash & lube

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.