![]() |
|
![]() |
#1 |
Registered User
Join Date: Feb 2007
Location: Marana, Arizona
Posts: 3,416
|
Column shifter sticky
I am sure there is a thread about this very thing , but I couldn't find it.
found some similar ones . Heres the deal ATM column shifter won't hardly go front (forward) or back (rearward) kinda tuff side to side (P to 1st) I lubed the linkage w/o pulling anything apart (underhood) seems to me the lever itself my be binding with dirt and corrosion at pivot ? Do I need to drive out roll pin and lube up or has something let loose inside ? Thanks in advance !
__________________
"I feel the need for speed!"... as soon as I am done with my nap. |
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Oct 2005
Location: Overland Park, Ks.
Posts: 5,217
|
Re: Column shifter sticky
Drive out the pin holding the lever in & pull the lever out. Spray a lubricant all around inside the hole. Spray some lube around the bottom of the column where the lever comes out that has the rod going to the trans. You can remove one 1/4 " bolt above the lower lever opening & one below & spray in the holes but don,t remove more then one at a time. That usually will fix it but if not you will have to pull the column & rebuild it.
|
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Feb 2007
Location: Marana, Arizona
Posts: 3,416
|
Re: Column shifter sticky
Thanks wrenchbender I will try that today and see what happens !
__________________
"I feel the need for speed!"... as soon as I am done with my nap. |
![]() |
![]() |
![]() |
#4 |
Senior Member
Join Date: Jan 2003
Location: daytonabeach
Posts: 22,956
|
Re: Column shifter sticky
first thing i'd do is disconnect the tranny linkage and see if it frees up the column if it does your problem isnt in the column
__________________
71c-10 350/2004r/4:11 lowered3/4 longbed/dead by hurricane MEANING OF DEATH::::: SOMEBODY ELSE GETS YOUR STUFF DONT BELIEVE EVERYTHING YOU THINK TAKE MY ADVISE;I DON'T USE IT ANYWAY |
![]() |
![]() |
![]() |
#5 |
ENGINE BUILDER
Join Date: Apr 2006
Location: Shortsville n.y.
Posts: 344
|
Re: Column shifter sticky
Mine has been sticky for a long time. I took out the pin and pulled the lever out of the column, and sprayed WD-40 in around where the tube slides up and down. Now it shifts nice!!!!!!
![]()
__________________
JIM ZAG |
![]() |
![]() |
![]() |
#6 |
Registered User
Join Date: Feb 2007
Location: Marana, Arizona
Posts: 3,416
|
Re: Column shifter sticky
FIXED I think ? had some really thick old grease very wax like , scrapped that off and pulled out some nylon chunks ? and lubed , now its very smooth .
A lil concerned about whatever "guide?" I pulled out but I'll give it a go . Thanks for your input !
__________________
"I feel the need for speed!"... as soon as I am done with my nap. |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|