Pics and layouts of Flowmaster Mufflers

[renegade8720]

Hi, as soon as my truck gets back from the body shop and I get it wired, I am heading to the muffler shop to have a set of Flowmasters installed with dual exhaust. I would like to see some pics of your exhaust systems and where you had the tips exit for some ideas for my truck.

Thanks in advance for any pics or advice,

Renegade

[QKENUF4U]

my guy turned mine sideways and put them beside the drive shaft then ran pipes over axle and out behind wheels. worked out very clean.
mine had the holes cut in the crossmember though so i had my exhaust all tucked up tight w/ nothing to drag.

[MisterE72]

This pic I downloded a while back may help. Its not a Flowmaster but...hey.

[tim21391]

i have pipes going into 2 flowmaster mufflers then going over my axle and exiting underneath my rear bumper....its dark out so i cant take pictures....wait til tomorrow and ill take pics and post them for you....it looks really good...if you go with flowmaster get the original 40 series you wont regret it....ppl say its too loud but i had my windows up and you didnt really notice it...roll them down and punch the gas oh man it sounds nice

[mixermike]

don't have any pics of the system but you can see where they exit

[renegade8720]

Originally Posted by tim21391

i have pipes going into 2 flowmaster mufflers then going over my axle and exiting underneath my rear bumper....its dark out so i cant take pictures....wait til tomorrow and ill take pics and post them for you....it looks really good...if you go with flowmaster get the original 40 series you wont regret it....ppl say its too loud but i had my windows up and you didnt really notice it...roll them down and punch the gas oh man it sounds nice

Look forward to seeing them.

Thanks,
Renegade

[tim21391]

ill get them hopefully pretty soon sometime today...i like the setup..they are nice

[tim21391]

[tim21391]

[tim21391]

[tim21391]

[tim21391]

[tim21391]

hey i hope these help your decision....i love this sound i have of flowmasters

[tim21391]

and if i were you i would get the stainless steel tips....here they cost me 80 bucks for both of them...you can get chrome ones cheaper but the chrome will rust and flake off..i had chrome circle tips and they looked bad when they rusted....stainless is the way to go in my opinion they shouldnt rust

[kaycee]

What series flows did u guys run r they loud,I'm looking to tone mine down a bit.

[tim21391]

im running original 40 series

[tim21391]

since my mufflers by the driveshaft under the bed i cant hear it when the windows are rolled up that much which is good but roll them down it sounds really good....my old ones were rusted on there so bad it sucked takin them off....if i ever have to do exhaust work again im takin it to a muffler shop

[tim21391]

YouTube - 1972 Chevrolet C-10 Flowmaster 40 Series

theres a video of my truck...i gotta 402 big block though

[Pl4yboy]

Super 40s, dumped above the axle... with a slight leak lol.

YouTube - Startup and Rev

and an old one...

YouTube - 69 Chevy startup

[corn]

[tim21391]

i say cant go wrong with flowmaster!!