53-Gas Tank/Crossmember/Boxed Frame/Parking Brake installed

[53lochevy]

Got the frame completly boxed with the boxing plates from progressive along with the crossmember I had bent up last week or so for 60 bucks in pipe and 60 bucks for the pipe bender. I just had a birthday yesterday and got the tank as a present from you know who thats right my Mom hehehe she asked what I wanted and what else does a gear head want hehehehe. I had to do alittle midification from the drawing that I had drew last week but it all went in great. If you look at the pic of the gas tank you can see the stock rear croosmember has been modified first cut the ears off the side and keep them you will reuse them later when you trim the crossmember as seen in the pic along with cutting the opening for the sending unit. Will put the anti-squeak between the side rails and the two straps underneath in final assembly. Still have to put the cross pieces to tie the crossmember together on both sides 3each side. Should get the air tanks installed this weekend inside the crossmember goal is fitting everything out of sight and tuck it neatly underneath her. Also modified the parking brake assembly as you can see by the pic I wanted to keep the parking brake because all the rest of the stock pedal are going to be gone and I wanted to keep that assembly in the truck I like the old looking parking brake in the floor along with the handle inside the cab on the side. Order the notch plates for the rear will get that done next week also. Boxing the frame and crossmember install along with the rear the frame is really stirdy and will be able to step on the gas alittle harder if ya know what I mean. Enjoy the pics and let me know what ya"ll think of the build so far. I really appreciate all the responses and this site is great for finding anything you what to know.

Thanks all

[53lochevy]

more pics

[53lochevy]

more pics

[53lochevy]

Once the rollpan is installed in the rear along with the bumper will fit the gas tank neck under the bed in the rollpan for a flip-license plate to hind it out of the way and not in the bed I never liked having to lift the gas nozzle over the tailgate or having to let the tailgate down in order to fill the tank, let alone spilling gas in the bed with the varnish on the wood. You should see about an 1 1/2 inches once the rollpan and bumper are install will go with the 55 model bumper with the cut out for the license plate.

[entourageguy]

Looks great. Love the center section you built.

[53lochevy]

thanks couldnt see paying 440 dollars shipped to the door for this crossmember from progressive but I did order the transmission mount from Bob at progressive. I just basically copied there design and looked at some pics here of the placement along with measurement for the ls1/460e transmission and bent it up quick and easy really, I used to be an engineer with GE and I was always helping out the instrumentation guys running my gear to the equipment at the plants so i came easy the transmission mount was 40 bucks not bad saved about 240 dollars and got a tool to boot.

[jkaylor68gmc]

that looks great, you did a terrific job with both the fuel tank and centersection.

josh