operation cab floor update

[truckn']

sorry guys I haven't figured out how to add pics to an existing thread so just wanted to show couple more pics of progress, not much got down with the flu for a few days. anyway put inner rocker on and clamped outer rocker in place to see if I kept it pretty straight, I don't expect perfect the first time but plan on improving as time goes along....By the way I saw a thread awhile back about drilling out weld spots then I bought one of those spot weld removal bits and it's alright but not near worth the money. I do electrical work and we use a UNIBIT to drill boxes and such. It works ten times better than the spot weld removal kit and lasts alot longer. you can buy them from 1/4 to 1/2 or bigger. the last pic is a picture of it if any of you are interested. you can buy at any lowe's or home depot.

[TimE]

Nice looking progress! I had thought about using a unibit but wasn't sure how well it would work, but you have apparently proven that it works well. Great job!!

[lyrikz]

Originally Posted by truckn'

sorry guys I haven't figured out how to add pics to an existing thread so just wanted to show couple more pics of progress, not much got down with the flu for a few days. anyway put inner rocker on and clamped outer rocker in place to see if I kept it pretty straight, I don't expect perfect the first time but plan on improving as time goes along....By the way I saw a thread awhile back about drilling out weld spots then I bought one of those spot weld removal bits and it's alright but not near worth the money. I do electrical work and we use a UNIBIT to drill boxes and such. It works ten times better than the spot weld removal kit and lasts alot longer. you can buy them from 1/4 to 1/2 or bigger. the last pic is a picture of it if any of you are interested. you can buy at any lowe's or home depot.

Unibit works, but i like to hav emetal left over. I use a real spotweld drill bit remover. From snap on.

Here it is.


That thing is money in the bank there..

[truckn']

yea that one looks like it would do a good job, cheap set I bought off of ebay pretty much got what I payed for.

[leftcoast66]

Nice work, gives me the motivation to get off my butt and put my new rockers on, layin in the garage since christmas.

[greg64]

Lookin good Truckin. Did you drill a pilot hole for the unibit, or did you just ram it through?

[truckn']

just put it through didn't seem to slip at all, I spent about 30 minutes with 5 spot welds the other day, took me about 5-6 minutes with the unibit.

[jonzcustomshop]

ttp for joey~ap