Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
|
03-11-2008, 09:50 PM | #1 |
Keep Your Nose Clean
Join Date: Dec 2006
Location: California
Posts: 496
|
How much SHOULD it cost?
Greetings folks, I'm getting ready to have the rear end housing reassembled. How much is a reasonable amount to pay to have this done? It is all apart right now because I had it powder coated. It is a 12 bolt posi with drum brakes. Anything can help at this point. Thanks.
|
03-12-2008, 12:05 AM | #2 |
LAIDOUT
Join Date: Jan 2005
Location: NW Montana
Posts: 928
|
Re: How much SHOULD it cost?
So you need the gears set and lashed then? I wonder what that costs as well. The machine shop here will shorten rear ends but won't do gear setup...
|
03-12-2008, 12:39 AM | #3 |
Registered User
Join Date: Oct 2006
Location: Oakridge Oregon
Posts: 1,864
|
Re: How much SHOULD it cost?
A good builder around here charges around $250 if your using brand new gears.
__________________
68 CST SWB - Gold/White 50th anniversary /TH350/Buddy Buckets/3.73 Posi/dogdish caps. 68 K10 Burb - Gold/White 327/SM465/NP205/3.73 "Daa Burb" build thread Last edited by Mt Man Chad; 03-14-2008 at 08:59 PM. |
03-12-2008, 12:50 AM | #4 |
Senior Member
Join Date: May 2002
Location: NORTHEAST OHIO
Posts: 493
|
Re: How much SHOULD it cost?
here too...anywhere from 200-300,with your parts
|
03-12-2008, 01:07 AM | #5 |
Registered User
Join Date: Dec 2006
Location: Saskatchewan
Posts: 119
|
Re: How much SHOULD it cost?
I just payed $240 to have my limited slip installed and a gear swap with all new bearings and seals.
__________________
71' Chevrolet -> 350c.i. w/ 600 Edelbrock Carb, Headers, P/S, 3/5 Drop |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|